Dismiss Notice
This Section is READ ONLY - All Posts Are Archived

I'm probably a fool, but can't seem to craft a pole

Discussion in 'Release 14 Feedback' started by j15r, Feb 1, 2015.

Thread Status:
Not open for further replies.
  1. j15r

    j15r Avatar

    Messages:
    29
    Likes Received:
    45
    Trophy Points:
    15
    Gender:
    Male
    Location:
    Atlanta
    According to the NPC at the crafting pavilion in Owl's Head, all I need is a wood rasp and a board. I have both (4 maple boards), but can't place just one board on the carpentry table to save my life. I've been able to craft from recipes in the book by double-clicking, but can't find any affordance to move part of a pile to the table. The ones that work in the inventory and stores (i.e., double-click, select quantity) appear to be missing here.

    Am I nuts, or otherwise missing something simple?
     
  2. NRaas

    NRaas Avatar

    Messages:
    3,984
    Likes Received:
    5,841
    Trophy Points:
    165
    Gender:
    Male
    Location:
    Glenraas

    Hold Ctrl or Shift down when dragging. One provides a prompt, and the other moves a single item. :)
     
    Tahru and j15r like this.
  3. Satan Himself

    Satan Himself Avatar

    Messages:
    2,702
    Likes Received:
    12,806
    Trophy Points:
    165
    You can get the recipe for the stripper pole from the stripper in Owl's Head. She'll also polish your sword for a fee.
     
    Tahru and j15r like this.
  4. j15r

    j15r Avatar

    Messages:
    29
    Likes Received:
    45
    Trophy Points:
    15
    Gender:
    Male
    Location:
    Atlanta
    Thanks. Damn, you'd think that after operating various GUIs over the past several decades, I'd have tried something like that. Still, not the most discoverable assurance...
     
    Tahru and Duke Raas like this.
  5. SmokerKGB

    SmokerKGB Avatar

    Messages:
    2,227
    Likes Received:
    2,805
    Trophy Points:
    165
    Gender:
    Male
    Location:
    Pittsburg, CA
    Last time I made one was at the Milling table...
     
    Tahru likes this.
Thread Status:
Not open for further replies.